Remove/install ball head

AR46.40-D-7242TS

Remove/install ball head

05.03.2020

Model

907, 910

Modification notes

03.03.2020

Nut, ball head to steering knuckle

BA46.40-N-1003-06TS

Shown on model 907, left side of vehicle

1

Ball head

2

Nut

3

Jam nut

4

Tie rod

Shown on model 910, left side of vehicle

1

Ball head

2

Nut

3

Jam nut

4

Tie rod

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 

Remove/install

1

Remove each front wheel.

AR40.10-D-1100TS

2

Unscrew nut (2) from ball head (1).

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

 Installation: Replace nut (2).

 Nut, ball head to steering knuckle

*BA46.40-N-1003-06TS

3

Unscrew counternut (3).

 To do so, counterhold ball head (1).

 Installation: Only tighten the jam nut (3) after checking and adjusting the toe.

 Counternut, tie rod to ball head

*BA46.40-N-1001-06TS

4

Pry ball head (1) off steering knuckle.

 Installation: Clean centering cone and contact surfaces of steering knuckle.

 Puller

*221589053300

5

Unscrew ball head (1) from tie rod (4).

 To do so, counterhold tie rod (4) at hexagon.

 Installation: Check ball head seal bellows (1) ball head (1) and tie rod (4) for signs of wear and damage.

If corresponding findings are present,



Replace ball head (1) or tie rod (4).

AR46.40-D-0202TS

6

Install in the reverse order

7

Perform chassis alignment.

AR40.20-D-0200TS

 Steering linkage

Number

Designation

Model 907, 910

BA46.40-N-1001-06TS

Counternut, tie rod to ball head

Nm

65

 Steering linkage

Number

Designation

Model 907, 910

BA46.40-N-1003-06TS

Nut, ball head to steering knuckle

Nm

100