1 | Inlet air pipe |
2 | Intake manifold |
3 | Electric cable (only in vehicles with Code (M89) Flame equipment) |
4 | Electrical connector (only in vehicles with Code (M89) Flame equipment) |
5 | Fuel pipe (only in vehicles with Code (M89) Flame equipment) |
6 | Bolt |
7 | Clamp |
8 | Supercharging air hose |
W09.41-1029-06
Only in vehicles with transmission 715.510/520/561 and Code (GS3) Hydraulic driven transmission and Code (IY2) Hydraulic fluid according to sheet 345.0 |
10 | Hydraulic pipe |
W26.60-1191-11
| Remove/install | ||
1 | Turn off ignition | ||
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut.. | |
2 | Tilt the cabin | ||
Topical note | Notes on tilting the cab | . | |
3 | Remove acoustic enclosure from the top left corner of the framework | ||
4 | Remove and separate engine hydraulic pipe (10) | Only in vehicles with Code (GS3) Hydraulic driven transmission. | |
Do not remove hydraulic pipelines (10). | |||
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
5 | Remove the electric cable (3) electrical connector (4) and fuel pipe (5) from the flame equipment | Only in vehicles with Code (M89) Flame equipment. | |
Installation: Replace the sealing rings. | |||
Collect the drained fuel. | |||
.Fuel line hollow screw in the electromagnetic valve in the flame system and in the filter housing | |||
6 | Loosen the clamp (7) and remove the supercharging air pipe (1) from the supercharging air hose (8) | Installation: check the state of the supercharging air hose (8) and clamp, replacing them if necessary. | |
.Fastening of the clamps on the inlet and outlet flexible hoses | |||
7 | Remove the screw (6) | ||
8 | Remove the supercharging air pipe (1) from the supercharging air ell (2) | Installation: clean the surface and replace the seal. | |
.Fastening of air distribution manifold to intake manifold | |||
9 | Install in reverse order |
参照文書
- ah6080n000301a ドライバ·キャビンのチルトに関する注意事項
- as4700z000101a 燃料が引火することによる爆発の危険、気化した燃料を誤って吸い込んだり、飲み込んだりすることによる中毒の危険、燃料が飛び散ることによる皮膚や眼の負傷の危険があり�
- as6080z000101a ドライバ·キャビンを傾ける際、手や指が挟みこまれ、怪我をする危険があります。