055 589 03 61 00
Puller
055 589 02 63 00
Installing device
B42.10-0365-03
For the brake caliper SN7000 follow the work steps 1 to 9:
1 The housing of the bronze bushing (7) will have to be clean and in perfect conditions. Eliminate any type of burr, if present.
2 The bronze bushing will have to be dry installed, with no lubrication at all.
3 Position the set of tools (K13) with the plain washer (AL), (K17), position the bronze bushing (7) and finally position the tool (K14).
4 Confirm the correct positioning of the tools before starting installing the bushing.
5 Turn the hexagon of the tool (K13) with an appropriate socket and start pressing in the bronze bushing (7) into its seat in the brake caliper.
It is important to observe the correct positioning of the bushing at the beginning of the pressing operation .
6 Continue turning the tool (K13) hexagon until concluding installation of the bronze bushing (7) in its seat in the brake caliper.
B42.10-0366-03
Inserting the bronze bushing:
7 Position the device (K10) and, on the expansion rod (H), apply three moderate strikes to start inserting the bronze bushing (7) at the point of the reentrance (7.1) of the housing.
8 Pull the expansion rod (H) in the direction indicated by the arrow (X) (only the minimum necessary) and turn the device approximately 90º in relation to the first insertion. Repeat the operation in order to obtain the 4 insertion points.
9 Remove the expansion rod (H) and next, the device (K10), normally.
B42.10-0365-03
For the brake caliper SN7000 follow the work steps 10 to 18:
10 The housing of the bronze bushing (7) will have to be clean and in perfect conditions. Eliminate any type of burr, if present.
11 The bronze bushing will have to be dry installed, with no lubrication at all.
12 Position the set of tools (K13),with the tool (K17) and the plain washer (AL), installed in the same. Place the new bronze bushing (7) and from the opposite side, screw (K13) in the tool (K14).
13 Confirm the correct positioning of the tools before starting the pressing.
14 Turn the hexagon of the tool (K13) with an appropriate socket and start pressing in the bronze bushing (7) into its seat in the brake caliper. It is important to observe the correct positioning of the bushing at the beginning of the pressing operation .
15 Continue turning the tool (K13) hexagon until completing the installation of the bronze bushing (7) in its housing.
B42.10-0366-03
Inserting the bronze bushing:
16 Position the spacer ring (K11) in the device (K10), place the expansion rod (H) in the device and apply three moderate strikes to carry out the insertion of the bronze bushing (7) at the point of the reentrance (7.1) in the housing.
17 Pull the expansion rod (H) in the direction indicated by the arrow (X) (only the minimum necessary) and turn the device approximately 90º in relation to the first insertion. Repeat the operation in order to obtain the 4 insertion points.
18 Remove the expansion rod (H), the spacer ring (K11) and next, the device (K10), normally.