1 | Brake disc |
2 | Wheel hub |
3 | Bolt |
B42.10-0411-01
| Remove/install | ||
1 | Remove the wheels | ||
2 | Remove the brake pads |
| |
3 | Remove the support with the brake caliper |
| |
Rear axles 743.453 | |||
4 | Remove the wheel hub (2) |
| |
5 | Remove the bolts (3) and the brake disc (1) from the wheel hub (2) | .Disk retaining screw (guide) | |
| Check | ||
6 | Check the brake disc conditions | The braking surfaces must be plain. | |
Deep grooves or scratches compromise the service life of the brake pads. | |||
Before grinding the disc, check the possibility of removing material. | |||
Do not reuse discs in which the thickness has reached the minimum limit. | |||
After machining, redo the disc bevels on the outside. | |||
Disk width | |||
Rotor outer nominal diameter | |||
Knocking (maximum lateral deviation). Measured 10 mm from outer rotor edge | |||
Rotor braking surface coarseness | |||
Disc outer edge chamfer, after machined | |||
Rotor braking surface parallelism | |||
7 | Install in reverse order | In the case of replacement by a new disc, remove the anti-corrosion protection from the friction surfaces. | |
When assembling the disc in the hub, pay attention so that the support surfaces are perfectly clean and free from burrs. |