AR42.10-B-0030C | Releasing combination cylinder mechanically | 12.02.16 |
Vehicle 979 with Rear axle 743.45 with CODE B02 (Anti-block system (ABS) for brakes)
B42.10-0507-11
Represented on rear axle 743.45
1 Combined cylinder
2 Plug
3 Nut
4 Accumulator spring recoil bolt
5 Relief bolt
X Locking position
Loosen | |||
1 | Chock the vehicle against unintentional displacement | In the case of no compressed air, the combined cylinder parking brake can be released mechanically. | |
The vehicle wheels are to be chocked whenever any brake system repair service occurs. | |||
2 | Remove the nut (3) and lift out the spring recoil bolt from the housing (4) | ||
3 | Disconnect the compressed air hoses from the combined cylinder (1) | Before disconnecting the hoses on the combined cylinder (1), it is necessary to identify them, to facilitate at assembly. | |
4 | Remove the plug (2) and lift out the relief bolt (5) on the combined cylinder (1) | ||
5 | Insert the relief bolt (5) again in the combined cylinder (1), and fit it in the slot of the emergency disc, turning 1/6 of one turn until locking it | ||
6 | Turn the nut of the relief bolt (5) and recoil the emergency spring until locking | The parking brake has to be deactivated, during the recoiling procedure up to the position of locking (X) of the emergency spring. | |
Actuate | |||
7 | Remove the relief bolt (5) from the combined cylinder (1) | Install the recoil bolt of the spring (4), and tighten the nut (3) to the specified torque. | |
| |||
8 | Connect the compressed air hoses of the combined cylinder (1) | Connect the hoses of the combined cylinder (1), according to the identification made, to facilitate in the assembly. | |
9 | Install the relief bolt (5) again in the combined cylinder (1) | ||
10 | Apply the parking brake |
Brake cylinder