Pull tapered roller bearing off drive pinion, press on
Tipo ar · tema 35.30 · versione 0201 · 2020-07-07
Valido per: Rear axle 743.451/453/454/458/480 in model 979.0
Non disponibile in “it”; mostrato in Inglese.
Collocazione
Gruppo funzionale 2 Telaio › 35 Asse posteriore › 35.30 Trasmissione, comando — Serie 979 (modelli 0**)
EinPAS 17 Organi della trasmissione/assale › 17.51 Assale posteriore › 17.51.65 Ingranaggi e differenziale al ponte posteriore/trasmissione passante — Serie 979 (modelli 0**)
Valido anche per motori/cambi: 743 451, 743 453, 743 454, 743 458, 743 480
AR35.30-B-4300-01B
Pull tapered roller bearing off drive pinion, press on
743.451/453/454/458/480
Rear axle
743.451/453/454/458/480 in model 979.0
055 589 02 33 00
Puller
1
Install the extraction plate (3) on the pinion shaft (1) base, so that it supports the bearing from below
2
Remove the bearing using a press
Install the flange nut (2) on the pinion (1). The nut prevents the pinion from falling when removing the bearing.
B35.30-0163-01
B35.30-0136-01
3
Heat the bearing to a temperature of approximately 80 °C
4
Install the bearing (4) onto the pinion shaft (1)
Observe the correct seating of the bearing.
Work with a protective sleeve when inserting the hot bearing in the pinion shaft.
