Rear axle ARS 19/23 |
1 | Nuts |
2 | Washers |
3 | Tapered washers |
4 | Axle shaft flange |
5 | Axle shaft |
6 | Gasket |
7 | Wheel hub |
B35.20-0009-01
4 | Axle shaft flange |
5 | Axle shaft |
B35.20-0005-01
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Chock the vehicle against unintentional displacement. Utilize closed and close fitting work clothes. Do not touch heated-up or moving parts. | |
| Remove | ||
1 | Remove the nuts (1), the washers (2) and the tapered washers (3) | ||
2 | Remove the axle shaft (5) | Support a plastic hammer at the center of the flange and hit it with a mallet to detach the tapered washers from the housing. | |
| Install | ||
3 | Install a new gasket (6) on the axle shaft flange (4) | ||
4 | Install the axle shaft (5) in the rear axle | Use a proper tool to ease the installation of the axle shaft (5). | |
5 | Install the washers (2), the tapered washers (3) and the nuts (1) | Slightly tighten all nuts and, then apply the prescribed torque. | |
The tightening should be performed crosswise. | |||
.Wheel hub axle shaft |