652 589 00 33 21
Hand pump
652 589 00 33 22
Hollow cylinder
950 589 01 33 00
Press-in/out tool
652 589 00 33 01
Removal and installation tool
652 589 00 33 02
Removal and installation tool
652 589 00 33 11
Threaded spindle
652 589 00 33 23
Hydraulic hose (complete)
950 589 02 33 00
Removal and installation tool
When removing and installing the bearing sleeves, make sure that bearing sleeves of various diameters are used, according to the extraction and assembly tool:
Para bucha Ø 58 mm 652 589 00 33 01
Para bucha Ø 60 mm 950 589 02 33 00
Para bucha Ø 65 mm 652 589 00 33 02
Para bucha Ø 75 mm 950 589 01 33 00
Remove
1 | Screw the threaded sleeve (2) to the hollow cylinder (1) and with the threaded spindle and the appropriate extraction and assembly tool into the bearing sleeve. |
2 | Join the hydraulic hose with the hydraulic pump to the hollow cylinder (1) and pull the bearing bushing in the direction of the arrow. |
W32.35-1038-01
Install
3 | install a new bearing sleeve (4) and the pressure piece for pressing (6) on the tapered sleeve (5). |
4 | Place the hollow cylinder (1) and the tapered sleeve (5) on the connecting rod and screw with the threaded spindle (7) and the hex nut (8). |
Place the tapered sleeve (5) with the bearing sleeve (4) always on the sloping side of the connecting rod. |
W32.35-1036-01
5 | Join the hydraulic hose and the hydraulic pump with the hollow cylinder (1) and insert the bushing in the bearing. |
Check, through the cavity (arrow) in the tapered sleeve (5), whether the sleeve is fully installed. |
W32.35-1037-01