Valido per: Transmission 715.358 in model 958.0/1 Transmission 715.372/382/388/527/531 in model 958.4 Transmission 715.517 in model 958.2 Transmission 715.535 in model 958.2
EinPAS 17 Organi della trasmissione/assale › 17.35 Sistema di innesto/comando delle marce › 17.35.31 Cilindro di comando/pistone di comando — Serie 958 (modelli 0**, 1**, 2**, 4**)
Valido anche per motori/cambi: 715 358, 715 372, 715 382, 715 388, 715 517, 715 527, 715 531, 715 535
AR26.35-B-1000-01A
Determine shim for shift piston of splitter group
Transmission
715.358 in model 958.0/1
Transmission
715.372/382/388/527/531 in model 958.4
Transmission
715.517 in model 958.2
Transmission
715.535 in model 958.2
Split group
Number
Designation
Gearbox 715.531/535
Gearbox 715.372/382
BE26.35-B-1001-01A
Splitter group control piston adjustment dimension
mm
0,3...0,5
0,3...0,5
Split group
Number
Designation
Gearbox 715.504/517/527/564
Gearbox 715.358
BE26.35-B-1001-01A
Splitter group control piston adjustment dimension
mm
0,3...0,5
0,3...0,5
1
Press-in the piston rod (1) against stop. The sliding sleeve will have to remain seated on the synchronizer ring.
The cover of the input shaft bearing will have to be assembled with the compensating washers.
The pass-through pin, closing the split group, will have to be installed.
2
With the depth gage (3) measure from the machined surface to the collar (2) of the piston rod (1) = Measurement A .
W26.35-0001-01
3
With the depth gage (3) measure from the machined surface to the collar (4) on the gearbox front part = Measurement B .
W26.35-0002-01
4
Calculate the compensating washer. .
Measure A - Measure B = Measure X
The required compensating washer will have to be thinner than the X measurement in a value equivalent to the specified adjusting measurement.
