1 | Pneumatic clutch central actuator |
2 | O-Ring |
3 | Bolt |
4 | Clutch course sensor |
5 | Connector |
6 | Gearbox |
B25.20-A004-06
| Remove | ||
1 | Remove the wiring harness from the connector (5) | ||
2 | Remove the connector (5) of the housing | Be careful not to damage the connector lock (5). | |
3 | Remove the screws (3) | ||
4 | Remove the pneumatic clutch central bearing (1) | ||
| Check | ||
5 | Check the pneumatic clutch central actuator (1) |
| |
In case of contamination with oil, any membrane spring of the pressure plate clutch broken, in case of signs of clutch overheating or malfunction: | |||
| |||
Replace the pneumatic clutch central actuator (1). | |||
| Install | ||
6 | Install a new O-Ring (2) on the pneumatic clutch central actuator (1) | Lubricate O-Ring (2) using grease. | |
7 | Install the pneumatic clutch central actuator (1) | Pneumatic clutch central actuator (1) must be fully compressed. | |
8 | Install the bolts (3) | .Clutch pneumatic actuator screw | |
9 | Install the connector (5) in the housing | | |
Align the connector (5) correctly with the housing. | |||
10 | Connect the harness to the connector (5) | ||
11 | Connect the diagnosis system, start the XENTRY and perform the quick test | The gearbox (6) must be installed on the vehicle. | |
When disassembling or replacing any component in the clutch assembly: | |||
| |||
Teach-in process should be performed, otherwise the gearbox (6) may malfunction. | |||
12 | Select the re-programming process "Re-program the coupling" | The procedure is completely controlled by the menu below: TCM - transmission control (A5) Adjustments Teach-in processes Teach-in the clutch. | |
13 | Finish the XENTRY and remove the diagnosis system |