ar1440d2001s

Remove/install injection line for exhaust aftertreatment system

Tipo ar · tema 14.40 · versione 0106 · 2019-07-15

Valido per: Engine 642 in model 906.6/7 with code MH1 (Low-emission engine EPA 10/CARB) except code KP2 (AdBlue tank, 12 l, in the engine compartment) Engine 642 in model 906.6/7 with code MH3 (Low-emission engine EPA 13/CARB) except code KP2 (AdBlue tank, 12 l, in the engine compartment)

Non disponibile in “it”; mostrato in Inglese.

Collocazione

Gruppo funzionale 1 Motore › 14 Collettore di scarico, freno motore, impianto di depurazione gas di scarico › 14.40 Post-trattamento gas di scarico, AdBlue — Serie 906 (modelli 6**, 7**)

EinPAS 15 Motore › 15.40 Impianto di scarico/post-trattamento dei gas di scarico › 15.40.13 Tubazione/flessibile/valvola — Serie 906 (modelli 6**, 7**)

Valido anche per motori/cambi: 642 ***

AR14.40-D-2001S

Remove/install injection line for exhaust aftertreatment system

28.06.2019

Engine

642 in model 906.6/7

with code MH1 (Low-emission engine EPA 10/CARB)

except code KP2 (AdBlue tank, 12 l, in the engine compartment)

Engine

642 in model 906.6/7

with code MH3 (Low-emission engine EPA 13/CARB)

except code KP2 (AdBlue tank, 12 l, in the engine compartment)

Remove/install injection line for exhaust aftertreatment system

D14.40-0088-09

Show on model 906.611

1

AdBlue® injection line

3

Stowage compartment

Y130

AdBlue® injection valve

2

AdBlue® tank

4

Retaining clips

Warning

Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning caused by swallowing AdBlue

Pour AdBlue into suitable containers only. Wait until the pressure is released before starting any work on the exhaust aftertreatment system.

AS14.40-Z-0001-01A

Notes on use, material properties and handling of AdBlue®

AH14.40-N-0001-01A

Remove/install

1

Remove stowage compartment (3) in the right entrance

2

Lift/jack up vehicle

AR00.60-D-1000H

3

Remove the AdBlue® tank (2)

AR14.40-D-2014S

4

Remove AdBlue® injection valve (Y130)

AR14.40-D-2000S

5

Open retaining clamps (4) for AdBlue® injection line (1)

6

Expose AdBlue® injection line (1) and remove

Observe routing of the AdBlue® injection line (1).

7

Install in the reverse order

Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

8

Perform an engine test run and check connections for AdBlue® injection line (1) for leaktightness

Documenti citati