Remove/install, set bracket of crank angle position sensor · ar0715i1640b · Mercedes-Benz WIS

AR07.15-I-1640B

Remove/install, set bracket of crank angle position sensor

22.3.07

ENGINE 904.941 in MODEL 684.482

W07.15-0081-06

1 Bracket

2 Shear-off screw

3 Locking bush

4 Flywheel

5 Cranking device

B15 Crank angle position sensor

	Removing
1	Pull out crankshaft position sensor (B15) at bracket (1)
2	Pull out locking bush (3)
3	Install cranking device (5) at timing case		AR03.30-W-1600-03A
			*BA01.60-N-1002-01A
			*BA01.60-N-1003-01A
			*904589046300
4	Turn crankshaft using turning device (5) until the marking (arrow below) stands in the middle to the bore in the holder (1)		*904589046300
5	Block crankshaft using turning device (5) against turning		*904589046300
6	Mark flywheel (4) relative to edge in the spy hole (arrow above)
7	Use a suitable tool to remove shear bolts (2) and take off bracket (1)
	Install
8	Align bracket (1) and tighten	 The marking (arrow below) on the flywheel (4) must stand in the middle towards the bore in the holder (1). Check marking on flywheel (4) relative to edge in inspection hole. Tighten shear bolts (2) fully until they shear off
9	Press locking bush (3) in as far as the stop.
10	Press crank angle position sensor (B15) into the timing case as far as the stop
11	Remove turning device (5) from timing case		AR03.30-W-1600-03A
			*BA01.60-N-1002-01A
			*BA01.60-N-1003-01A
			*904589046300

 Timing case

Number	Designation		Engines 900.9, 902.9, 904.9, 906.9


BA01.60-N-1002-01A	Inspection hole closure cover to timing case	Nm	25
BA01.60-N-1003-01A	Bolt, turning device to timing case	Nm	25

Cranking device

904 589 04 63 00

ar0330w160003a Montare e smontare il dispositivo di rotazione e bloccaggio motore