High and low beam |
B82.10-0025-01
B82.10-0026-01
Foglamp |
B82.10-0001-01
| Check | ||
1 | Reestablish tires inflation pressure, including spare wheel |
| |
Bus | |||
Headlights alignment should be executed with unloaded vehicle, in flat ground and with calibrated tires. | |||
Aligning with optical sensor | |||
2 | Place the aiming instrument in front of the headlight to be aimed and position it following the equipment maker's instructions | ||
3 | Switch on the low beam headlights | The bright-dull limit line, to the left of the center point, must be located on the horizontal line; and at the right of the center point it must be deviated upwards. | |
If it is not prescribed above: | |||
| |||
Actuate on the headlight setting screws to correct the position of the beam. | |||
4 | Switch on the low beam headlights | High beam center should fall on central point (A) within the frame limit. | |
For headlights with double filament light lamps (low beam and high beam), after adjusting the low beam, high beam regulation must be automatically performed, only check. If the high light alignment appears excessively incorrect: | |||
| |||
Replace the headlight lamp. | |||
Small high light divergences are tolerable. | |||
In headlights with lamps of a filament (high light), if necessary: | |||
| |||
Correct the alignment of the headlight by acting on the adjusting screws. | |||
Fog headlight alignment | |||
5 | Place the aiming instrument in front of the headlight to be aimed and position it following the equipment maker's instructions | On vehicles with fog lights | |
Adjust the fog lights beam so that the boundary between light and dark is located on the horizontal separation line. |