Gear assembly
D26.50-0051-02
Remove
1 Turn the reverse gear shaft (10) with the gear counterclockwise (arrow) and pull it simultaneously up and out of the gearbox.
D26.50-0052-01
Measuring
2 Measure the length "A" of the clamping bushes and compare it with the prescribed measure (see table).
In case they are different, adjust the prescribed measure moving the clamping bush.
D26.50-0053-02
Install:
3 Install the reverse gear shaft (10) with the clamping bush in the opening of the gearbox back side and turn it clockwise (arrow) until the reverse gear touches the secondary shaft of the gearbox.
Rotate the reverse gear shaft (10), so the tapped holes match the ones on the front side of the gearbox.