SM97.30-D-0022A | Perform corrosion prevention measure | 27.7.10 |
MODEL 906.155
Sprinter NCV3 minibus with SA code ZJ8 Transfer and Travel
D97.30-1106-01
Figure 1 Left side measured from front wheel arch lip of rear axle
a 700 mm
b 1200 mm
c 1420 mm
d 2350 mm
D97.30-1107-01
Figure 2 Right side measured from front wheel arch lip of rear axle
e 700 mm
f 1200 mm
Operation no. of operation texts or standard texts and flat rates
Category | Op. no. | Operation text | Acc. no. | Code |
L | 026916 | Perform corrosion prevention measure on side wall | 6190070 | EVOUNTER |
| List of affected vehicles | Model 906 from | |
| Remove/install | ||
1 | Make drain hole | On the left side measured from the front wheel arch lip of the rear axle (Figure 1). On the right side measured from the front wheel arch lip of the rear axle (Figure 2). | |
In the area of the lower end profile drill a drain hole through the GRP panel and the square tube of the framework with a 10 mm diameter drill bit. | |||
2 | Apply cavity wax inside the drain hole | Insert the spraying hose or lance as far as possible into the frame profiles in all directions through the preservation holes. Spray the wax while inserting and removing. | |
Advantageous are nozzles which spray toward the front as well as at an angle toward the rear. Drain holes allow condensation to drain off and must not be closed. | |||
Preservation | |||
Underfloor protection |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1002-05A | Wax for bottom of vehicle (1 l container) | A 000 986 42 70 10 |
BR00.45-Z-1017-05A | Underfloor protective wax (black, 1 l container) | A 004 989 79 20 |