P77.30-2301-09
2 Roll bar
3 Screw
4 Bracket
5 Vario roof crossmember
9 Screw
10 Main flap
11 Side flap
6 Screw
7 Securing clamp
8 Pull/push actuation
P77.30-2299-04
1 Rear shelf
10 Main flap
11 Side flap
12 Vario roof front section
| Remove | ||
1 | Switch on ignition, open Vario roof with Vario roof actuation switch. Then switch off ignition | Stop Vario roof motion before trunk lid starts closing and the rear shelf (1) main flap (10) is positioned vertically.Approx. 15 s after removing the transmitter key, the pressure in the Vario roof hydraulic system is relieved completely and the rear shelf (1) can be moved manually for other activities. | |
2 | Remove inner paneling from rollover bars (2) | ||
3 | Fold main flap (10) of rear shelf (1) downward manually | ||
4 | Unscrew bolts (3) and remove both mounts (4) from Vario roof crossmember (5) | The jacketing of the rollover bar (2) should be pushed upward by hand until the bolts (3) can be reached with the tool. | |
5 | Unscrew bolts (6) on left and right side of vehicle | ||
6 | Position main flap (10) of rear shelf (1) vertically by hand | ||
7 | Remove retaining clip (7) from left and right pull/push actuation (8) | ||
8 | Unclip right pull/push actuation (8) from left and right side flap (11) | ||
9 | Unscrew bolts (8) from left and right side of vehicle | ||
10 | Remove rear shelf (1) upward from vehicle | Remove rear shelf (1) carefully.Danger of damaging paint on Vario roof front section (12). | |
| Install | ||
11 | Position rear shelf (1) in vertical position on installation location | Position rear shelf (1) carefully. Danger of damaging paint on Vario roof front section (12). | |
12 | Apply bolt securing agent to bolt thread (9) and tighten bolts (9) on left and right side of vehicle | | |
Loctite 262 | |||
13 | Position main flap (10) of rear shelf (1) horizontally by hand. | ||
14 | Apply bolt securing agent to bolt thread (6) and tighten bolts (6) on left and right side of vehicle | | |
Loctite 262 | |||
15 | Install right pull/push actuation (8) on left and right side flap (11) | ||
16 | Install retaining clip (7) on right pull/push actuation (8) | On vehicles up to vehicle identification number 032031: Replace retaining clip (7), unless a new version of retaining clip (7) is already installed. | |
| Retaining clips for right pull/push actuation on side flaps changed | Vehicles as of vehicle identification number 032032 | |
17 | Position both mounts on Vario roof crossmember (5) and tighten bolts (3) | ||
18 | Check tension of main flap (10) in relation to trunk lid, correct if necessary | See: | |
Adjust Vario roof rear shelf | |||
19 | Install inner paneling on rollover bars (2) |
Soft top
Repair materials
Number | Designation | Order number |
BR00.45-Z-1059-02A | Loctite 262 | Henkel Loctite Deutschland GmbH |