P64.20-4286-09
Scope of repair shown on vehicle with left C-pillar completely removed
1 Completely install rear floor assembly (1), fit and fasten to body using vise grip pliers and C-clamps.
2 Bend over floor panel (2) in marked areas (arrows) and fasten to complete rear floor assembly (1) by tack welding
3 Complete rear floor assembly (1) in areas A to C .
P64.20-4287-09
4 Complete rear floor assembly (1) in area E .
5 Complete rear floor assembly (1), on side of side wall still installed, in area D .
6 Complete rear floor assembly (1), on side of side wall installed, in area F .
P64.20-4288-05
7 Floor panel (2) in areas G to J .
Weld through inert gas weld in areas G to J. Perform welding in intervals, allow to cool down in between. This ensures minimum heat distortion.
8 Weld inert gas weld down to bare metal in areas G to J.
Grind inert gas weld down flat in areas G to J on floor (2) due to reasons of operational stability and costs
9 Clean all spot welds with wire brush