Commercially available tools
Number | Designation | |
WH58.30-Z-1003-02A | Clamping pliers | |
WH58.30-Z-1031-02A | C-clamp | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1002-03A | Straight grinder (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
P63.30-2265-06
1 Fit front outer longitudinal member shell (1) and fasten with clamping pliers.
2 Tack weld front outer longitudinal member shell (1) to body
Other spot welds required can be completed together with the A-pillar reinforcement and side wall paneling.
3 Weld in front outer longitudinal member shell (1) in area A, along dotted line with .
Weld all the way through in area A.Weld in intervals, allow to cool down in between. This minimizes the heat distortion.
4 Grind weld down flat in area A on contact surfaces of side wall paneling
5 Grind connection surfaces down to bare metal in area A.
Do not grind down flat remaining MIG weld in area A on front outer longitudinal member shell (1) due to reasons of operating stability and cost
6 Grind all welds down flat if required
7 Clean all other spot welds with wire brush