1 Align outer A-pillar (1) and inner A-pillar center section (2) with one another and tighten bolts (3).
P63.20-5231-03
P63.20-5232-06
2 Insert outer A-pillar (1) together with inner A-pillar section (2), align and fasten to straightening tool.
Do not loosen bolts (3) for alignment.
3 Fasten outer A-pillar (1) and inner A-pillar center section (2) to body using vise grip pliers and C-clamps.
4 Screw in bolts (4).
5 In area T on inner A-pillar center section (2) .
P63.20-5233-12
6 In area S on outer A-pillar (1) .
7 In area N on outer A-pillar (1) .
Spot weld in area P together with side wall paneling.
P63.20-5074-05
8 In area Q on outer A-pillar (1) .
Spot weld in area R together with side wall paneling.
P63.20-5234-08
9 Drill through Ø 4 mm holes in areas B and C on outer A-pillar (1).
10 Countersink drilled holes with Ø 8 mm bit on one side
Countersink alternately from inside and outside
Areas not accessible from both sides can also be countersunk continuously on one side.
11 In areas A to F on outer A-pillar (1) .
P63.20-5071-05
12 In areas H to K on outer A-pillar (1) .
Spot weld in areas G and L together with side wall paneling.
P63.20-5072-05
13 In area M on outer A-pillar (1) .
14 Grind all spot welds down flat if required.
15 Clean all other spot welds with wire brush