Cable set
970 589 00 31 00
W60.80-0024-06
Shown on model 970
A Securing cab for work during which the cab has to be tilted further forward or back with a crane or forklift
1 Remove rubber plugs (1) from openings (2) on end plate.
2 Insert the two locking fingers (3) of fastening strap (4) into openings (2) on end plate and arrest behind internal, reinforced plate.
Insert locking finger side, on which locking lug is located, further outside.
W60.80-0025-06
3 Hook fastening strap (4) onto crane hook (5).
4 Fasten fastening strap (6) to hole (8) in end plate with screw eye (7).
If hole (8) on right side is not free, attach cable on left.
5 Attach holder (10) to free hole in longitudinal frame member
On body 375.810 install bracket (10) outside on frame.
6 Insert fastening strap (6) into wedge clamp (9), tension slightly and clamp by knocking slightly with hammer onto wedge.
7 Also tension fastening strap (4) slightly with crane.
W60.80-0026-06
B Securing cab for work during which it is not necessary to move the cab from the tilting position or repair position:
1 Tilt cab forward to repair position without tilting cylinder.
2 Fasten fastening strap (6) to hole (8) in end plate with screw eye.
If hole (8) on right side is not free, attach cable on left.
3 Attach bracket (10) to free hole in longitudinal frame member
4 Insert fastening strap (6) into wedge clamp (9), tension slightly and clamp by knocking slightly with hammer onto wedge.