P49.10-0221-06
| Removal, installation | ||
| Risk of explosion | Pay attention to accident prevention regulations! | |
1 | Remove exhaust system downstream of flanged connection, install | ||
2 | Mark exhaust pipes between center and rear mufflers (7, 9) at the points specified and saw off | Size "B" = 110 mm | |
If the rear muffler (9) was already replaced, always saw off the widened pipe end at the center muffler (7) (size "A" = 95 mm) | |||
3 | Fit together sawn-off center muffler (7) and new rear muffler (9) | Use exhaust pipe clips (7/2) | |
When attaching the exhaust system, ensure that the projection "a" of the bracket at the rear muffler is not more than 3 – 5 mm at the rubber bush (18) when system is cold | |||
4 | Install in the reverse order |