ar4225w2000na

Remove/install electronic brake control (EBS) control unit

Tyyppi ar · aihe 42.25 · versio 0100 · 2013-02-22

Koskee: MODEL 967 with CODE B1B (EPB with ABS and ASR)

Ei saatavilla kielellä ”fi”; näytetään kielellä Englanti.

Sijainti

Toimintoryhmä 2 Alusta › 42 Jarrujen hydrauliikka ja mekaniikka › 42.25 Elektronis-pneumaattiset jarrut (EPB) — Mallisarja 967

EinPAS 21 Jarrut/alipainelaite/paineilmajärj. › 21.15 Käyttöjarru/alipainelaite › 21.15.11 Ohjainlaite/rele — Mallisarja 967

AR42.25-W-2000NA

Remove/install electronic brake control (EBS) control unit

20.12.2012

MODEL

967

with CODE B1B (EPB with ABS and ASR)

Remove/install electronic brake control (EBS) control unit

A10b

Electronic brake system (EBS) control unit

W42.25-1352-11

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Connect diagnostic system, start XENTRY and perform quick test

Only if the Electronic Brake Control (EBS) control unit (A10b) is to be replaced.

The quick test is stored at the end of the diagnosis session as the initial quick test and can be printed out.

2.1

Perform control unit replacement

If the Electronic Brake Control (EBS) control unit (A10b) is to be replaced.

Control unit replacement is completely menu-assisted under:
"EBS - electronic brake system (A10b)"
"Adaptations"
"Initial startup"
"Control unit replacement"

Installation:Follow "Control unit replacement" instructions.

2.2

Switch off ignition

If the Electronic Brake Control (EBS) control unit (A10b) is not to be replaced.

3

Remove paneling

AR68.10-W-3435K

4

Disconnect electrical connectors from Electronic Brake Control (EBS) control unit (A10b)

5

Remove Electronic Brake Control (EBS) control unit (A10b)

6

Install in the reverse order

Viitatut asiakirjat