Attach transverse control arm to steering knuckle and front axle beam
Tyyppi ar · aihe 33.20 · versio 0112 · 2009-11-17
Koskee: FRONT AXLE 730.408 /410 in MODEL 901, 902 FRONT AXLE 730.409 in MODEL 902 FRONT AXLE 730.409 /413 in MODEL 903 FRONT AXLE 730.411 /414 in MODEL 904 FRONT AXLE 732.2 in MODEL 690.6
Ei saatavilla kielellä ”fi”; näytetään kielellä Englanti.
Koskee myös moottoreita/vaihteistoja: 730 408, 730 409, 730 410, 730 411, 730 413, 730 414, 732 2**
AR33.20-D-1452-03A
Attach transverse control arm to steering knuckle and front axle beam
Wheel location, hub
Number
Designation
Front axles 730.408/409/410/ 411/413/414/ 415/606
Front axle 732.2 in model 690.6
BA33.20-N-1003-01A
Bolt, stop plate to transverse control arm
M10
Nm
60
60
BA33.20-N-1005-01A
Nut, wishbone to steering knuckle
M201.5
Nm
280
280
D33.20-0002-01
1 Coat rubber springs of wishbone (12) with oil.
2 Support wishbone (12) with jack.
3 Insert front wishbone arm into bearing bracket and fix with wishbone bolt (2).
Replace nut on wishbone screw joint, but do not tighten.
4 Lower jack under wishbone.
D33.20-0004-01
5 Insert the rear wishbone arm into the bearing bracket and fix with wishbone bolt (2).
Replace nut on wishbone screw joint, but do not tighten.
D33.20-0021-01
D33.20-0020-01
6 Bolt stop plate (7) onto wishbone (12) .
7 Position the steering knuckle (10) on the wishbone joint, fit the heat shield (only axle 730.411/414) and screw the retaining nut (13) on to the wishbone joint .
