Remove/install front stabilizer bar linkage

AR32.35-S-3330P

Remove/install front stabilizer bar linkage

12.11.2018

Model

470, 471

Modification notes

07.11.2018

Special tool 000 589 69 03 00 Box wrench bit added.

Operation step 2

Shown on model 470, on left side of vehicle

1

Nut

2

Stabilizer bar linkage

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Warning

Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension

Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves.

AS00.00-Z-0001-01A

Notes on repair work on suspension components

AH00.00-P-0100-01A

 

Remove/install

1

Raise vehicle.

AR00.60-S-1000-04P

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01P

2

Unscrew nuts (1) from left or right torsion bar linkage (2).

Note on calculation of tightening torque when using insertion or socket tools with various effective lengths

AH00.00-P-0015-01CW

 Nut, torsion bar linkage to front axle stabilizer bar/lower control arm

*BA32.35-N-1002-02P

 Box wrench bit

*000589690300

3

Remove left or right torsion bar linkage (2).

4

Install in the reverse order.

 Front axle stabilizer bar

Number

Designation

Model 470, 471

BA32.35-N-1002-02P

Nut, torsion bar linkage to front axle stabilizer bar/lower control arm

Nm

107