AR32.20-D-0200-02B | Install transverse leaf spring | ||
| Wooden block for clamping transverse leaf spring |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1015-06A | Vaseline | Karl Käppler GmbH & Co. KG Liebknechtstr. 48 |
D32.20-0013-01
1 Make a center marking on transverse leaf spring and front axle beam.
2 Bond the top spring rubber mounts to the bearing backets and clip into the fixtures at the subframe.
Pay attention to installation position and location!
Black bearing bracket = left side of vehicle
Rubber bush without colored marking = left side of vehicle
Red bearing bracket = right side of vehicle
Rubber bush with red colored marking = right side of vehicle
3 Grease underside of rubber bush (arrow).
D32.20-1104-01
4 Coat spring bearing with assembly oil and push onto ends of springs as far as the stop.
The angled edge must be pointing up.
5 Grease both rubber bushes at the spring ends to facilitate installation.
D32.20-1105-01
6 Insert transverse leaf spring with the outer spring mounts into the recess in the left and right wishbone.
The center markings on the spring and axle beam must be aligned.
D32.20-0010-01
7 Use vehicle jack and square timber to tension transverse leaf spring against the two stop spring mounts.