Disassemble/assemble rear hollow shaft with rear freewheel

AR27.50-D-0850A

Disassemble/assemble rear hollow shaft with rear freewheel

03.12.2013

TRANSMISSION

722.681 in MODEL 902.6, 903.6, 904.6, 905.6

TRANSMISSION

722.683 in MODEL 906.1/2/6/7

TRANSMISSION

722.684 in MODEL 906.1/2/6/7

TRANSMISSION

722.685 in MODEL 906.1/2/6/7

TRANSMISSION

722.686 in MODEL 906.1/2/6/7

1

Hollow shaft

2

O-ring

3

Retaining ring

4

Freewheel

5

Rear sun gear (with internal plate carrier of clutch K3)

6

Retaining ring

A

Thrust plate

 

Remove/install

1

Remove automatic transmission

TRANSMISSION 722.681 in MODEL 902.6, 903.6, 904.6, 905.6

AR27.10-D-0502A

TRANSMISSION 722.683/684/685/686 in MODEL 906.1/2/6/7

AR27.10-D-0502B

 

Disassemble/assemble

2

Remove transmission housing from torque converter housing

AR27.50-D-0601A

3

Disassemble the transmission into its main components

AR27.50-D-0603A

4

Disassemble output shaft with center and rear gear set

AR27.50-D-0810A

5

Remove retaining ring (6)

 Installation: Check that retaining ring (6) is correctly seated.
Replace O-rings (2) after installing circlip (6).

6

Remove rear sun gear (5) complete with internal plate carrier and freewheel (4)

 Installation: Install hollow shaft (1) on freewheel (4) and press in while turning counterclockwise.

7

Remove retaining ring (3)

8

Remove freewheel (4) from rear sun gear (5)

 Installation: The thrust plate (A) of freewheel (4) must face towards the retaining ring (3).

9

Assemble in the reverse order

10

Install in the reverse order