AR26.50-D-2002-01D | Remove/install reverse idler shaft with reverse gear | ||
| Notes on self-locking nuts and bolts |
Gear set, shafts
Number | Designation | Trans-mission | Trans-mission | |||
BA26.50-N-1002-01D | Mounting bolt, reverse idler shaft to transmission housing | M8 | Nm | 20 | 20 | |
D26.50-1244-11
1 Screw
2 Cylindrical roller bearing
3 Reverse gear
4 Reverse idler shaft
5 Bearing shell
6 Transmission housing rear section
Removing
1 Remove bolt (1).
2 Remove bearing shell (5).
3 Pull out reverse idler shaft (4).
4 Remove reverse gear (3) and cylindrical roller bearing (2).
Checking
5 Check all components for damage and wear and replace defective components.
Install
6 Oil reverse idler shaft (4) and cylindrical roller bearing (2) lightly with automatic transmission fluid.
7 Attach the cylindrical roller bearing (2) and reverse gear (3) to the reverse idler shaft (4).
8 Insert reverse idler shaft (4)
9 Insert bolt (1) and align threaded hole of reverse idler shaft (4) with the bolt (1).
10 Pull out bolt (1) again.
11 Mount bearing shell (5) with new bolt (1) .
The inscription on the bearing shell (5) must point towards the output side.
Viitatut asiakirjat
- ah0000n000101a Itselukittuvia ruuveja ja muttereita koskevia huomautuksia