ar0941p2002cd

Remove/install charge air temperature sensor

Tyyppi ar · aihe 09.41 · versio 0104 · 2012-05-08

Koskee: ENGINES 651 in MODELS 166, 172, 204, 207, 212, 218, 221

Ei saatavilla kielellä ”fi”; näytetään kielellä Englanti.

Sijainti

Toimintoryhmä 1 Moottori › 09 Imuilmanotto, ahtaminen › 09.41 Ahtoilmaputki/välijäähdytys — Mallisarja 166 · Mallisarja 172 · Mallisarja 204 · Mallisarja 207 · Mallisarja 212 · Mallisarja 218 · Mallisarja 221 · Mallisarja 651

EinPAS 15 Moottori › 15.30 Imuilmanotto/ahtaminen › 15.30.12 Tunnistin/katkaisin/johtosarja — Mallisarja 166 · Mallisarja 172 · Mallisarja 204 · Mallisarja 207 · Mallisarja 212 · Mallisarja 218 · Mallisarja 221 · Mallisarja 651

AR09.41-P-2002CD

Remove/install charge air temperature sensor

23.4.12

ENGINES 651 in MODELS 166, 172, 204, 207, 212, 218, 221

Remove/install charge air temperature sensor

P09.41-2543-06

4 Electrical connector

5 Screw/bolt

6 Engine charge air duct

B17/8 Charge air temperature sensor

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

1.1

Remove underfloor paneling

Model 166.0

AR61.30-P-1001GQ

1.2

Remove soundproofing bottom section in the center

Model 172.4

AR94.30-P-5300W

Model 204.9

AR61.20-P-1105CY

Model 204.0/2/3, 207, 212, 218

AR94.30-P-5300EW

1.3

Detach lower engine compartment paneling

Model 221 except CODE (Z07) Top protection

AR61.20-P-1105SX

2

Disconnect electrical connector (4) from charge air temperature sensor (B17/8)

The electrical connector (4) also, at the time, secures the snap-in bracket on the charge air temperature sensor (B17/8).

3

Press together snap-in bracket and disengage charge air temperature sensor (B17/8) at the mount

Do not unlatch or latch charge air temperature sensor (B17/8) with the electrical connector (4) to ensure that the snap-in bracket is not overstretched. Always replace charge air temperature sensor (B17/8) with defective snap-in brackets.

Installation: Replace sealing ring.

4

Pull out charge air temperature sensor (B17/8)

5

Install in the reverse order

Viitatut asiakirjat