Remove/install retaining lock for crankshaft/ring gear

AR03.30-S-5000SE

27.10.09

ENGINES 272, 642 in MODEL 639

ENGINES 642.896 /898 /992 /993 in MODEL 906

ENGINES 272 in MODEL 636

P03.30-2100-06

Engine 642 in model 639

1 Cover

2  Retaining lock

D03.30-1124-06

Engine 642 in model 906

1 Cover

2  Retaining lock

D03.30-1141-12

Engine 272 in model 636 and model 639

3 Screw

4 Protective cover

 	Remove/install
1	Lift/jack up vehicle	Model 636, 639	AR00.60-S-1000S
		Model 906	AR00.60-D-1000H
2	Remove bottom engine compartment paneling	On model 636 or on Model 639.7/8 as of vehicle identification end number 055347	AR61.20-S-1105S
3	Remove cover (1)	On model 639 with engine 642 or on model 906 with engine 642
			*BA15.30-N-1005-01G
4	Remove protective cover (4)	On model 636, 639 with engine 272
5	Remove screws (3)	On model 636, 639 with engine 272
			*BA27.10-N-1001-04A
6	Insert retaining lock (2) in opening	 The retaining lock (2) must engage in the ring gear of the flywheel or clutch plate, if necessary crank the engine at the crankshaft in the direction of engine rotation.
		 Retaining lock	*112589034000
7	Install in the reverse order

 Starter

Number	Designation		Engine 642


BA15.30-N-1005-01G	Cover on starter opening on crankcase	Nm	40

 Automatic transmission complete

Number	Designation			Model 636, 639 with transmission 722.6


BA27.10-N-1001-04A	Automatic transmission to engine	M10	Nm	38

Retaining lock

112 589 03 40 00