Remove/install retaining lock for crankshaft/ring gear

AR03.30-P-5000VA

Remove/install retaining lock for crankshaft/ring gear

21.2.08



Installing, removing

1

Raise vehicle with vehicle lift

AR00.60-P-1000V

2

Remove bottom engine compartment paneling

AR61.20-P-1105V

3

Detach assembly flap at the engine

 The starter must not be removed.



Checking

4

Check toothing of ring gear on two-mass flywheel or on drive plate

 Check the splines for wear and damage by continuing to rotate the engine at the center bolt of the crankshaft in the engine's direction of rotation. If necessary: 

Replace two-mass flywheel or drive plate.

AR03.30-P-8001V

 Danger!

Risk of injury caused by moving parts that can pinch, crush or, in extreme cases, even sever extremities

No parts of the body or limbs should be within the operating range of the mechanism when moving components.

AS00.00-Z-0009-01A

5

Insert the retaining lock (5) into the access opening and allow it to latch into the ring gear

 If required, rotate the engine further at the center bolt of the crankshaft in the engine's direction of rotation until the retaining lock (5) snaps completely into place.



*112589034000

6

Remove in the reverse order