Prepare engine support fixture during repair work in vehicle

AR01.10-P-0105-02MFA

Prepare engine support fixture during repair work in vehicle

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Engine

139, 260, 282, 608, 654 in model 118, 177, 247

Shown on model 177 with engine 139

Shown on model 177 with engine 260

Shown on model 177 with engine 282 on left side of vehicle

Shown on model 177 with engine 654

Shown on model 177 with engine 608

Shown on model 177 with transmission 724.1

Shown on model 177 with transmission 724.0

Shown on model 177 with transmission 700.4 on the right side of the vehicle

Shown on model 177 with transmission 711.6 on the right side of the vehicle

1

Attach left and right bracket (02) to the connecting carrier (1).

 The arrows on the brackets (02) must point in the direction of travel.

2

Attach strut (03) with safety bolt (04) to the brackets (02).

 Engine 139, 260, 282, 608, 654 in model 118, 177, 247
The marking R on the strut (03) must be on the right side of the vehicle.

 Model 118, 177, 247 with transmission 724.0, 724.1, 700.4, 711.6
The marking R on the strut (03) must be on the left side of the vehicle.

3

Attach basic carrier (05) to the strut (03).

 Tighten brackets (02) and the strut (03) only once the basic carrier (05) is under the lift support point.

4

Tighten locking clip (010) in the basic carrier (05) finger-tight.

5

Insert anti-twist lock (06) and tighten nuts (07) slightly by hand.

6

Install spindle (D) in the basic carrier (05).

7.1

Model 118, 177, 247 with engine 260, 608 model 118, 177, 247 with transmission 724.0, 724.1
Screw adaptation (H) onto the spindle (D).

7.2

Engine 139, 282, 654 in model 118, 177, 247 model 118, 177, 247 with transmission 700.4
Screw stamp (01) onto the spindle (D).

8

Insert plate (08) as shown in the strut (03) and secure with the bolts (09) against falling down.

9.1

Engine 260, 608 in model 118, 177, 247
Screw in spindle (D) until the adaptation (H) makes contact.

9.2

Engine 139, 282, 654 in model 118, 177, 247
Screw in spindle (D) until the stamp (01) makes contact.

9.3

Model 118, 177, 247 with transmission 711.6
Screw in spindle (D) until the spindle (D) inserts into the mount of the transmission.