P88.50-2986-04
Picture 1
P88.50-2987-04
Picture 2
1 Adhesive strips
2 Adhesive pad
a 65 mm
b 10 mm
c 8 mm
Operation no. of operation texts or standard texts and flat rates
Category | Op. no. | Operation text |
P | 026433 | Check trim strip on trunk lid |
P | 026434 | Replace trim strip on trunk lid (after check) |
| List of affected vehicles | Model 212 from | |
| Checking | ||
1 | Check gap dimension of trunk lid trim strip | Using a strip of paper Check (picture 1). | |
If no gap is present between the trunk lid and trim strip, proceed with operation step 2. If a gap is present between the trunk lid and trim strip, end measure. | |||
| Remove/install | ||
2 | Remove trunk lid handle | ||
3 | Remove trim strip | Using assembly wedge. | |
4 | Clean bonding surfaces | With silicone cleaner. One roll of adhesive tape is to be used for approx 250 vehicles. | |
5 | Position new trim strip | To do this, clip trim strip into trunk lid and align. | |
6 | Remove protective foil | On adhesive strip (1). Do not pull off protective foil of both individual adhesive pads (2) on the new trim strip (picture 2). | |
7 | Attach adhesive pads (2) | Only if the two adhesive pads (2) are not on the new trim strip. | |
8 | Install new trim strip | ||
9 | Install trunk lid handle strip |
Parts ordering notes
Part no. | Designation | Quantity |
A 212 743 00 82 05 | Trunk lid trim strip | 1 |
A 008 989 20 85 | Adhesive tape | 1 |
Referenced documents
- ar8850p5062ew Remove/install trunk lid handle
- sm8885p000201aaa Affected vehicles: Check trunk lid trim strip