sm8820p0008a

Replace rear bumper lower part (code: 19P8891102)

Type sm · topic 88.20 · version 0101 · 2020-02-18

Applies to: Model 167 with code 772 (AMG styling - Front spoiler, side skirts)

Where it sits

Function group 3 Body › 88 Detachable body components, exterior flaps › 88.20 Bumpers — Series 167

EinPAS 35 Body/frame/detachable parts › 35.38 Bumper/spoiler/outer trim/stowage box/front protective paneling › 35.38.31 Rear bumper — Series 167

EinPAS 45 Data/information › 45.20 Information/measures › 45.20.40 Service measures — Series 167

SM88.20-P-0008A

Replace rear bumper lower part (code: 19P8891102)

18.02.2020

Model

167

with code 772 (AMG styling - Front spoiler, side skirts)

Replace rear bumper lower part (code: 19P8891102)

P88.20-A025-08

1

Mounting clip

2

Mounting clip

Replace rear bumper lower part (code: 19P8891102)

P88.20-A026-09

3

Mounting clip

5

Retaining tab

4

Cover

6

Mounting clip

Check

1

Check, whether the vehicle is affected by the measure.

Remove/install

2

Remove rear bumper.

AR88.20-P-2200ME

3

Remove rear switch module (N38).

Only valid with code 871 (Sensor system for trunk lid opening/closing)

AR80.61-P-0011ME

4

Remove rear switch module upper sensor (A87/1) and rear switch module lower sensor (A87/2) with holder.

Only valid with code 871 (Sensor system for trunk lid opening/closing)

AR80.61-P-0012ME

5

Remove rear left center parking system distance sensor (B8/11) and rear right center parking system distance sensor (B8/12).

Only valid with code 235 (Active Parking Assist)

AR54.65-P-0002ME

6

Remove holders with tailpipe trims on left and right.

To do so, release tailpipe trims at retaining clips (1).

7

Remove reflectors at left and right.

To do so, release reflectors at retaining clips (2).

8

Remove trim piece.

To do so, release trim piece at retaining clips (3).

9

Remove cover (4) of towing eye and retaining tab (5).

10

Separate lower part from upper part of bumper.

To do so, release lower part from upper part of bumper at retaining clips (6).

11

Install in the reverse order.

Replace lower part of rear bumper and cover of towing eye.

Parts ordering note

Part no.

Designation

Quantity

A 167 885 62 00

Lower rear bumper cover

A 167 885 63 00

Lower rear bumper cover

A 167 885 65 00

Lower rear bumper cover

A 167 885 66 00

Rear bumper eyelet cover

*The replacement parts are to be identified according to the equipment variant for the vehicle identification number through the parts process in the XENTRY Portal.

Small parts such as screws, stop nuts, sealing rings, cable ties, fluids, sealant etc. are not listed in the parts list. The required small parts are taken into account in the cost framework.

Referenced documents