SM88.10-D-0020-02SG | Subsequently modify front fender liner in removed state (code: V3ABRADVER, acc. no.: 42 960 89) | ||
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. |
The following operation steps are shown on components on the right side of the vehicle and must be performed in the same way on components on the left side of the vehicle.
D88.10-A002-79
1 | Front section of fender liner | b | Dimension (approx. 130 mm) | |
2 | Rear section on fender liner | c | Dimension (approx. 14 mm) | |
a | Dimension (approx. 21 mm) |
Adapt front section of fender liner (1)
1 | Mark separation lines on front section of fender liner (1) as shown. |
Observe dimension (C). |
2 | Detach front section of fender liner (1). |
To do so, separate front section of fender liner (1) at separation line using a suitable tool (e.g. carpet blade). |
The remaining piece (3) can be reused as a template. |
3 | Use suitable tool to deburr edges. |
Adapt rear section of fender liner (2)
4 | Mark separation lines on rear section of fender liner (2) as shown. |
Observe dimensions (A, B). |
5 | Detach rear section of fender liner (2). |
To do so, separate rear section of fender liner (2) at separation line using a suitable tool (e.g. carpet blade). |
The remaining piece (4) can be reused as a template. |
6 | Use suitable tool to deburr edges. |
Referenced documents
- as0000z001701a Risk of injury caused by scraping or cutting body parts on sharp vehicle parts