sm5465p0010a

Program parking system control unit (code: 1604P54B25)

Type sm · topic 54.65 · version 0103 · 2019-11-13

Applies to: Model 213 with code 503 (Remote-controlled parking)

Where it sits

Function group 2 Chassis › 54 Electrical system, equipment and instruments › 54.65 Parking assist — Series 213

EinPAS 28 Convenience system/driver assistance system › 28.15 Parking Assist › 28.15.11 Control unit/relay — Series 213

EinPAS 45 Data/information › 45.20 Information/measures › 45.20.40 Service measures — Series 213

SM54.65-P-0010A

Program parking system control unit (code: 1604P54B25)

13.11.2019

Model

213

with code 503 (Remote-controlled parking)

Operation no. of the operation texts or standard texts and flat rates

Category

Op. no.

Operation text

Time

Acc. no.

Code

P

02-4762

Connect/disconnect diagnostic system (XENTRY/DAS)

P

02-5058

Connect/disconnect battery charger (with XENTRY/DAS connected)

P

02-9334

Update control unit ......................... software (with XENTRY/DAS connected), Acc. no.: .........., code: ..........

Check

1

Check whether vehicle is affected by measure


Model 213.### ## as of 000834 up to 029472
with code 503 (Remote-controlled parking)

SM54.65-P-0010-01AAA

Programming

2

Connect diagnostic unit

Use XENTRY Diagnostics version 05/2016 or higher with all available add-ons. Please make sure to follow the steps exactly as described in XENTRY Diagnostics. Make sure that the vehicle's on-board electrical system battery has sufficient voltage supply (more than 12.5 V) by using a battery charger. If Xentry Diagnostics is already connected to the vehicle, continue with operation step 3.

AD00.00-P-2000-04B

3

Program parking system control unit (N62)

The prompt before and after the control unit update for carrying out a calibration drive must be ignored.
The notes will be discontinued with the next XENTRY Diagnostics update.

To do so, select menu item Control units view  Driver assistance systems  PTS Parktronic system Adaptations  Control units update  Update of control unit software.

Then follow the user guidance in XENTRY Diagnostics.

If two or more instances of control unit programming or SCN coding are carried out during a workshop visit, the operation items 02­4762 and 02­5058 must only be charged once for each workshop order.

4

Disconnect diagnostic equipment

AD00.00-P-2000-04B

XENTRY Diagnostics stays connected in case a check/test procedure is required.

Referenced documents