Update format of vehicle identification number

SM00.10-W-0076A

Update format of vehicle identification number

19.06.2020

Model

930, 932, 933, 934, 963, 964

Code: MCM-VIN

Operation no. of the operation texts or standard texts and flat rates

Category

Op. no.

Operation text

Time

Acc. no.

Code

N

541011

Perform quick test

0,3 h

-

-

N

541022

Create output report (with XENTRY/DAS connected)

0,1 h

-

-

N

021829

Update format of vehicle identification number (model 930, 932, 933, 934)

0,2 h

00 930 64

MCM-VIN

N

021829

Update format of vehicle identification number (model 963, 964)

0,1 h

00 930 64

MCM-VIN

1

Connect diagnostic system, start XENTRY and switch on ignition.

 At least XENTRY update 03/2020 with add-on 15719 must be installed for the update.

2

Perform initial quick test.

 The initial quick test is stored until the end of the diagnosis session.

3

Update format of vehicle identification number in engine control (MR) control unit.

Only on model 930, 932, 933, 934.

 The process is completely menu-assisted under:
MR - Engine management control unit 
Control unit adaptations 
Writing of FIN into the engine management MR control unit (valid for China)
The procedure is menu-assisted. A password must be entered during the procedure. The password is an arbitrary 6-digit combination.

4.1

Update format of vehicle identification number in base module (BM) control unit.

Model 930, 932, 933, 934

 The process is completely menu-assisted under:
BM - base module control unit 
Control unit adaptations 
Teach-in processes 
06 Writing of FIN into base module control unit (valid for China)
The procedure is menu-assisted. A password must be entered during the procedure. The password is an arbitrary 6-digit combination.

4.2

Update format of vehicle identification number.

Model 963, 964

 The process is completely menu-assisted under:
Diagnosis 
special functions 
Special measures 
Enter "SMCGWMCM200501" 
Enter password.
The procedure is menu-assisted. A password must be entered during the procedure. The password is an arbitrary 11-digit combination.

5

Perform final quick test.

 There must be no fault codes in the control units being updated.

If fault codes are still present in control units being updated,



then process the fault codes.

 After obtaining special order.

6

End XENTRY and remove the diagnostic system.