si6010p0002d

Service Information on straightening set

Type si · topic 60.10 · version 0100 · 2005-06-13

Applies to: MODELS 211

Where it sits

Function group 3 Body › 60 Body - general › 60.10 Straightening bench, straightening accessory — Series 211

EinPAS 35 Body/frame/detachable parts › 35.15 Measurements/straightening bench › 35.15.30 Straightening bench — Series 211

EinPAS 45 Data/information › 45.20 Information/measures › 45.20.20 Service information — Series 211

SI60.10-P-0002D

Service Information on straightening set

1.6.05

MODELS 211

Service Information on straightening set

P60.10-2164-02

1 Supporting sleeve unmachined

2 Supporting sleeve machined

A Ø = 20 mm

B 10 mm

After production start-up of model 211, the torx bolts for mounting the rear engine mount (transmission crossmember) were phased out and replaced by hexagon bolts. The supporting sleeves 7211.7020 are contained in the Celette straightening bracket set 7211.300. The blind holes of the supporting sleeves are designed with a diameter of 15 mm for the torx bolt heads.

The blind holes must be drilled or hollowed out 10 mm deep with a diameter of 20 mm (see picture) so that the supporting sleeves can be used for the torx and hexagon bolt heads.