30-3402 Removing, Adjusting and Installing Bowden Cable
Preceding work: | Operation no. of operation texts and work units or standard texts and flat rates: 30-3402 |
A Typ 201
B Typ 124
C Typ 140
Bowden cable (230) | detach at accelerator control lever (208). Remove, install guide piece (240) on accelerator control lever for this step. |
Plastic clip (228) | compress and remove, install Bowden cable (230). |
Cover below instrument panel | (Model 140) remove, install. |
Footwell covering | (Models 124, 201) remove, install. |
Locking element (217) | (Model 201) remove, fit on again. |
Spring (235) | (Models 124, 201) remove, install. |
Bowden cable mount | (Model 140) at accelerator pedal lever (233), detach, attach. |
Vacuum lines for key-operated engine stop | withdraw from rubber grommet, insert. |
Bowden cable (230) | press outwards, ensuring that the rubber grommet (231) is not pressed out. |
Adjusting screw (229) | adjust full throttle stop. |
Adjusting nut (232) | adjust idle stop. |
Rubber grommet (231) | ensure correct position. |
Accelerator control | adjust (30-1010). |
Note
Use anti-corrosion grease
Part No. 000 989 87 51 10 when performing assembly work on the accelerator control.
Referenced documents
- ra3000602pr04x Programmed Repairs Engines 602.96, 603.96/97 Combustion 30 - Accelerator control
- ra300a6021010x 1010 - A. Adjusting Accelerator Control Linkage Engine 602.96 in Models 124, 201
- ra300b6021010x 1010 - B. Adjusting Accelerator Control Linkage Engine 603.96 in Model 124
- ra300c6021010x 1010 - C. Adjusting Accelerator Control Linkage Engines 602.96/97 in Model 126
- ra300d6021010x 1010 - D. Adjusting Accelerator Control Linkage Engine 603.971 in Model 140