gf8370s2011s

Stationary heater (STH) operating time, function

Type gf · topic 83.70 · version 0102 · 2016-05-10

Applies to: Model 639.601/603/605/701/703/705/711/713/811/813/815 as of 9/1/08 with code H12 (Auxiliary hot-water heater) with code HY1 (Radio remote control for aux. water heater)

Where it sits

Function group 3 Body › 83 Climate control › 83.70 Auxiliary/supplementary heater — Series 639 (models 601, 603, 605, 701, 703, 705, 711, 713, 811, 813, 815)

GF83.70-S-2011S

Stationary heater (STH) operating time, function

10.05.2016

Model

639.601/603/605/701/703/705/711/713/811/813/815 as of 9/1/08

with code H12 (Auxiliary hot-water heater)

with code HY1 (Radio remote control for aux. water heater)

Change operating time via the stationary heater (STH) radio remote control (RRC [FFB]) for auxiliary heater

With FFB switched on and light-emitting diode (LED) flashing red at the STH FFB, briefly press the activate button and the "OK" button at the same time twice in rapid succession. The LED of the STH FFB then lights up green. Now press the activate button repeatedly until the required operating time is displayed.

The following intervals can be set:

20 min: The LED of the STH FFB flashes green twice.

30 min: The LED of the STH FFB flashes green 3 times.

40 min: The LED of the STH FFB flashes green 4 times.

60 min: The LED of the STH FFB flashes green 6 times.

Once the operating time has been selected, the "OK" button must be pressed. The LED illuminates in red for the duration of the data transfer. If the LED performs 2 long green flashes, the selected operating time has been saved. If no settings have been made, the LED flashes 6 times and the STH RRC [FFB] goes into the idle state.

STH heater unit, location/task/design/function

GF83.70-S-4060S

Stationary heater/heater booster control unit, location/task

GF83.70-S-4002S

Fuel metering pump, location/purpose

GF83.70-S-4008S

Stationary heater switch, location/task

GF83.70-S-4056S

Referenced documents