GF07.03-S-2100A | Injector location/task/design/function | 25.5.98 |
ENGINE 611.980 in MODELS 638.094 /194 /294
S07.03-2503-09
Design
50/1 Flat connector
50/2 O-ring
50/3 Solenoid core
50/4 Sleeve
50/5 Solenoid tensioning nut
50/6 Solenoid
50/7 Adjustment shim
50/8 Rod-type filter
50/9 Pressure pipe connection
50/10 Sealing washer
50/11 Ball guide
50/24 Shim
50/25 Ball
50/26 Armature pin
50/27 Adjustment shim
50/28 Armature disk
50/29 Valve tensioning screw
50/30 Armature spring
50/31 Armature plate
50/32 Lock washer
50/33 Valve spring
50/34 Outlet connection
50/35 Setting ring
50/45 Needle guide
50/12 Valve ball
50/13 Sealing ring
50/14 Valve section
50/15 Valve plunger
50/16 Valve set
50/17 Nozzle body
50/18 Nozzle needle
50/19 Nozzle
50/20 Nozzle tensioning nut
50/21 Spiral tensioning pin
50/22 Thrust piece
50/23 Nozzle spring
Injector location | |||
Injector task | Generate a fine fuel carburetion for injection into the cylinder. This should also take place for high fuel pressures (approx. 1,350 bar) and for small injection rates (approx. 1.5 mm3/stroke). | ||
Injector design | The injector comprises a solenoid valve with ball seat, a control plunger and an injection valve. | ||
Injector function |
Referenced documents
- gf0703s210001a Injector position
- gf0703s210002a Injector function