Installation instructions
Battery charge retention unit 54.01
Models 140
The installation instructions are divided up into the following sections:
A. Installation kit for battery charge retention unit
C. Model 140
F. Parts ordering scope
A. Installation kit for battery charge retention unit
P54.10-0227-57
Installation kit for battery charge retention unit
6 | Washer (for model 202 only) |
7 | Charge retention unit |
8 | Adaptor cable |
9 | Extension cable |
1 | Bracket (for model 140 only) |
2 | Bolt (for model 140 only) |
3 | Washer (for model 140 only) |
4 | Charging socket with wiring harness |
5 | Nut |
Note
The installation kit for the battery charge retention unit can be used with the charging socket (4) or with the adaptor cable (8).
C. Model 140
P54.10-0229-57
Location of components
5 | Nut |
7 | Charge retention unit |
8 | Adaptor cable |
9 | Extension cable |
b | 20 mm dia. hole |
X4/5 | Connector, terminal 30/trunk (1-pin) |
W7/1 | Ground, right taillamp in trunk |
1 | Bracket |
2 | Bolt |
3 | Washer |
4 | Charging socket with wiring harness |
Bracket (1) with bolt (2) and washers (3) | Insert and secure. |
Charging socket with wiring harness (4) and |
Insert and secure. |
The following cables | connect: Red/green cable to connector (X4/5) in trunk, brown cable to ground, right taillamp in trunk (W7/1). |
Right side trim | install. Mark position of charging socket (hole B) on the back of the side trim, remove side trim. |
20 mm dia. hole (b) | make in the right side trim. Install side trim. |
F. Parts ordering scope
The parts ordering scope for retrofitting the fuse box F4 depends on the vehicle equipment.
Parts ordering scope, model 202 as of 12/94.
Item | Designation | Part number |
11 | Fuse box F4 | 202 545 14 01 |
12 | Extension bridge | 000 545 25 02 |
13 | Contact | 006 545 36 26 |
Contact | 006 545 37 26 | |
Wiring harness | 202 540 10 30 | |
Wiring harness | 202 540 19 30 | |
Cover | 202 545 08 03 | |
Nut | 003 990 02 51 | |