P82.85-9927-04
pic. A
1 GPS antenna
2 GPS antenna cable
3 Grommet
4 Bottom of A-pillar trim
5 Front bracket
N10/10 SAM control unit
P82.85-9931-03
| Install | ||
1 | Disconnect battery ground cable | ||
| Disconnect/connect battery ground cable | ||
2 | Remove wheelhouse paneling from the front left fender | ||
3 | Position GPS antenna (1) on reinforcement for left front side wall | Picture A. The CBS front was only removed to improve the illustration. It is not necessary to remove it to mount the GPS antenna (1). | |
The GPS antenna base is magnetic. Ensure that the GPS antenna base is positioned flat on the side wall reinforcement. | |||
4 | Route the GPS antenna cable (2) to the left front side wall reinforcement (arrows) | Picture A. The CBS front was only removed to improve the illustration. It is not necessary to remove it to mount the GPS antenna cable (2). | |
The GPS antenna cable (2) must be routed and secured in such a way so as to prevent damage and noise from vibrations. | |||
5 | Route the GPS antenna cable (2) on the cable duct for the side turn signal wiring harness to the interior | Picture A. The CBS front was only removed to improve the illustration. It is not necessary to remove it to mount the GPS antenna cable (2). | |
The grommet (3) from the side turn signal wiring harness of the second cable duct has to be cut open. Ensure that it remains leaktight. | |||
6 | Install wheelhouse paneling at the front left fender | ||
7 | Remove radio | ||
| Remove/install radio | ||
8 | Remove instrument cluster | ||
| Remove/install instrument cluster | ||
9 | Retrofit vehicle speed signal cable | The navigation unit may only be installed with the adapter wiring harness/vehicle speed signal cable provided. | |
10 | Install instrument cluster | ||
| Remove/install instrument cluster | ||
11 | Remove A-pillar trim at bottom (4) | ||
12 | Remove tie straps on front bracket (5) | Installation: Install new tie straps. | |
13 | Release SAM control unit (N10/10) from front bracket (5) | Fold down SAM control unit (N10/10), do not remove. | |
14 | Route GPS antenna cable (2) along the main wiring harness to the radio slot | The GPS antenna cable (2) must be routed and secured in such a way so as to prevent damage and noise from vibrations. | |
15 | Mount SAM control unit (N10/10). | Risk of fire caused by a short circuit. When closing the SAM control unit (N10/10) make sure cables are not pinched. | |
16 | Insert tie straps on front bracket (5) | Installation: Install new tie straps. | |
17 | Install A-pillar trim at bottom (4) | ||
18.1 | Process reinforcement for center console | Only for vehicles produced up to 01.09.03. In addition to this, 2 mm must be ground off of the upper edge on the installation opening of the reinforcement for the center console. | |
19 | Install navigation unit | The GPS antenna plug also has to be connected. | |
| Remove/install radio | ||
20 | Connect ground cable to battery | ||
| Disconnect/connect battery ground cable | ||
Final operations | |||
21.1 | Add special equipment to the vehicle data card and to the online vehicle data card | Only at workshops without DMS Autoline 8.0 dealer system. | |
Navigation unit (DFO/FFO), code C15. |
Referenced documents
- ar5410p0003rr Disconnect ground lead from battery
- ar5430p6015rr Removing and installing instrument cluster
- ar8260p7502rr Remove/install radio
- az8285p200301a Retrofit vehicle speed signal cable