ar9129p1431sc

Remove/install backrest motor for front seat

Type ar · topic 91.29 · version 0100 · 2007-06-15

Applies to: MODEL 216.3 Backrest angle adjustment motor

Where it sits

Function group 3 Body › 91 Seats, bunks, restraint systems › 91.29 Seats - electrical system — Series 216 (models 3**)

EinPAS 37 Interior equipment › 37.26 Front seat › 37.26.47 Seat adjustment — Series 216 (models 3**)

AR91.29-P-1431SC

Remove/install backrest motor for front seat

6.6.07

MODEL 216.3
Backrest angle adjustment motor

Remove/install backrest motor for front seat

P91.29-2519-09

Shown on right front seat

1 Clamping plate

2 Axle

3 Cable tie

4 Electrical connector

M27/5 Left front backrest angle adjustment motor

M28/5 Right front backrest angle adjustment motor

5 Bearing bushing

6 Shaft

7 Pliers

8 Rag

Remove/install

1

Remove seat-back lining from front seat backrest

AR91.10-P-1910SC

2

Removing front seat backrest upholstery

AR91.10-P-1090SC

3

Detach clamping plate (1) from axle (2)

Installation: Replace clamping plate (1).

4

Remove cable tie (3)

5

Disconnect electrical connector (4)

Release electrical connector (4) carefully, risk of breakage to electrical connector plug (4). The plug is not available as a replacement part.

6

Detach left front backrest angle adjustment motor (M27/5) or right front backrest angle adjustment motor (M28/5) from the shaft (6) and axle (2)

Observe bearing bushing (5).

Installation: Use suitable pair of pliers (7) to turn shaft (6) far enough until the left front backrest angle adjustment motor (M27/5) or the right front backrest angle adjustment motor (M28/5) can be slipped onto the axle (2). When doing so, protect the shaft (6) against damage using a rag (8).

7

Install in the reverse order

8

Normalize front seat

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

Referenced documents