P91.50-2080-06
1 Roll bar unit
2 Bolts
3 Plug connections
4 Cable harness
5 Lug
M53/1 Left rear head restraint motor
M53/2 Right rear head restraint motor
P91.50-2082-09
1 Roll bar unit
M53/1 Left rear head restraint motor
M53/2 Right rear head restraint motor
7 Thrust piece
8 Butyl tape
| Removing | ||
Danger! | Risk of injury when performing check and repair work in area of roll bar | Before working in the area of the roll bar, pull out the rear head restraints by hand. Keep body parts out of the area where the roll bar extends. | |
Danger! | Risk of injury caused by moving parts that can pinch, crush or, in extreme cases, even sever extremities | No parts of the body or limbs should be within the operating range of the mechanism when moving components. | |
1 | Cover vehicle in rear area | To prevent scratching the paint during assembly work. | |
2 | Remove roll bar unit (1) | ||
3 | Remove bolt (2) | ||
4 | Disconnect connectors (3) | ||
5 | Remove cable harness (4) from lug (5) | ||
6 | Remove left (M53/1) or right (M53/2) rear head restraint motor | Remove left (M53/1) or right (M53/2) rear head restraint motor with recumbent roll bar unit (1). | |
7 | Remove thrust piece (7) from left (M53/1) or right (M53/2) rear head restraint motor | ||
| Install | ||
8 | Fasten thrust piece (7) to left (M53/1) or right (M53/2) rear head restraint motor using butyl tape (8) | The thrust piece (7) must be coated lightly with special antifriction agent. The installation position of the thrust piece (7) is illustrated in the picture. | |
Special sliding compound | |||
Sealing | |||
9 | Install left (M53/1) or right (M53/2) rear head restraint motor | When retracting the left (M53/1) or right (M53/2) rear head restraint motor, make sure that the thrust piece (7) is retracted correctly (arrow). | |
10 | Place wire harness (4) into lug (5) | ||
11 | Connect connectors (3) | ||
12 | Screw in screws (2) | | |
13 | Install roll bar unit (1) | ||
14 | Remove cover in rear area | ||
Checking | |||
15 | Perform a function test | To perform function test, open soft top. Head restraint function: Pull out head restraint manually and lower using the instrument panel operating switch. | |
Crash function: Activate the roll bars using Star Diagnosis and then lower manually. |
Roll bar mechanism
Repair materials
Number | Designation | Order number |
BR00.45-Z-1050-01A | Top rear folding roof sealing | A 170 795 11 98 |
BR00.45-Z-1055-06A | Special sliding compound | A 000 989 36 60 |
Referenced documents
- ar9150p2355qa Remove/install roll bar
- as0000z000901a Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities.
- as9100z000301qa Risk of injury when performing check and repair work in area of roll bar