ar9129p1421pv

Removing, installing drive for seat height adjustment

Type ar · topic 91.29 · version 0100 · 2003-06-17

Applies to: MODEL 463.241 with CODE (979) Special protected version with CODE (SM1) Left rear electrically adjustable single seat with armrest with CODE (SM2) Right rear electrically adjustable single seat with armrest

Where it sits

Function group 3 Body › 91 Seats, bunks, restraint systems › 91.29 Seats - electrical system — Series 463 (models 241)

EinPAS 37 Interior equipment › 37.26 Front seat › 37.26.47 Seat adjustment — Series 463 (models 241)

EinPAS 37 Interior equipment › 37.27 Rear seat › 37.27.47 Seat adjustment — Series 463 (models 241)

EinPAS 37 Interior equipment › 37.28 Passenger seat › 37.28.46 Seat adjustment — Series 463 (models 241)

AR91.29-P-1421PV

Removing, installing drive for seat height adjustment

12.4.00

MODEL 463.241
with CODE (979) Special protected version
with CODE (SM1) Left rear electrically adjustable single seat with armrest
with CODE (SM2) Right rear electrically adjustable single seat with armrest

Removing, installing drive for seat height adjustment

P91.29-2127-11

1 Screw for seat height adjustment motor

Removing, installing drive for seat height adjustment

P91.29-2128-11

2 Bracket screws

3 Bracket

4 Plastic tab

5 Plug-in wiring connection

6 Plug-in wiring connection

7 Wire tie

M18m1 Seat height adjustment motor on left

M19m1 Seat height adjustment motor on right

Removing, installing

1

Adjust rear seat all the way forward.

2

Remove the screws securing the seat height adjustment motor (1).

Pull up the seat until access to the screws (2) and the plug-in wiring connection (5, 6) is available.

3

Cut off the wire ties (7).

4

Separate the plug-in wiring connection (5, 6) from the seat height adjustment motor (M18m1 on left, M19m1 on right).

Mark the terminals to prevent incorrect connections later on.

5

Remove screws from bracket (2).

6

Remove bracket (3) from seat frame.

Installation: Apply a light coating of grease to the plastic tab (4) prior to installation.

7

Remove seat height adjustment motor (M18m1 on left, M19m1 on right).

8

Install by reversing the removal sequence.

9

Run an operational check on the rear seat.

See Operating Instructions