ar9121d5746ec

Remove/install paneling at right side of bench seat housing

Type ar · topic 91.21 · version 0100 · 2005-08-10

Applies to: MODEL 903.6 with CODE (ZL9) "James Cook" touring camper

Where it sits

Function group 3 Body › 91 Seats, bunks, restraint systems › 91.21 Passenger seats — Series 903 (models 6**)

EinPAS 37 Interior equipment › 37.28 Passenger seat › 37.28.70 Trim/stowage — Series 903 (models 6**)

AR91.21-D-5746EC

Remove/install paneling at right side of bench seat housing

18.3.05

MODEL 903.6 with CODE (ZL9) "James Cook" touring camper

Remove/install paneling at right side of bench seat housing

D91.21-0006-09

1 Bolts

2 Bolts

5 Trim panel

3 Bolt

4 Bolts

 	Remove/install
 Danger!	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.	AS00.00-Z-0011-01A
1	Remove bench		AR91.21-D-4000EC
2	Remove cover caps from screws (1)
3	Remove bolts (1)	 Painted shims.
4	Release seat bolster and fold up	 See Operator's Manual
5	Remove cover caps from screws (2)
6	Loosen bolt (2)	 Painted shims.
7	Tilt bench seat to rear
8	Remove bolt (3)	 Installation: Bolt (3) is fastened on inside with a clamp, which has to be fitted again.
9	Remove screws (4).
10	Remove trim panel (5)
11	Install in the reverse order

Referenced documents

ar9121d4000ec Remove and install bench
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.