ar9121d5745ec

Remove/install front trim panel on bench seat housing

Type ar · topic 91.21 · version 0100 · 2005-08-10

Applies to: MODEL 903.6 with CODE (ZL9) "James Cook" touring camper

Where it sits

Function group 3 Body › 91 Seats, bunks, restraint systems › 91.21 Passenger seats — Series 903 (models 6**)

EinPAS 37 Interior equipment › 37.28 Passenger seat › 37.28.70 Trim/stowage — Series 903 (models 6**)

AR91.21-D-5745EC

Remove/install front trim panel on bench seat housing

18.3.05

MODEL 903.6 with CODE (ZL9) "James Cook" touring camper

Remove/install front trim panel on bench seat housing

D91.21-0003-09

1 Bolt

2 Bolt

5 Trim panel

6 Indicating plates

3 Bolts

4 Plastic disks

Remove/install

Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Remove bench

AR91.21-D-4000EC

2

Release seat bolster and raise up

See Operator's Manual

3

Remove cap of bolt (1)

4

Remove bolt (1)

Painted washer.

5

Tilt bench seat back

6

Unscrew bolt (2).

Installation: Bolt (2) is secured from the inside with a clamp that must be fitted again on installation.

7

Remove bolts (3)

8

Remove plastic disks (4)

9

Remove trim panel (5)

Installation: Attach indicating plates (6) when replacing trim panel (5).

10

Install in the reverse order

Referenced documents