ar9110s1915a

Removing and installing front seat backrest shell

Type ar · topic 91.10 · version 0101 · 2000-07-27

Applies to: MODEL 638.2

Where it sits

Function group 3 Body › 91 Seats, bunks, restraint systems › 91.10 Front seats — Series 638 (models 2**)

EinPAS 37 Interior equipment › 37.26 Front seat › 37.26.70 Trim/stowage — Series 638 (models 2**)

AR91.10-S-1915A

Removing and installing front seat backrest shell

4.3.97

MODEL 638.2

Removing and installing front seat backrest shell

S91.10-2510-06

1 Locating tab

2 Guide sleeve

3 Bolt

4 Neck rest guide

5 Snap-in lug

6 Backrest shell

7 Storage compartment fastening points

Removing, installing

1

Remove left and/or right center armrest

Up to VIN 225108.

AR91.27-S-1000A

As of VIN 225109.

AR91.27-S-1000B

2

Remove guide sleeves (2)

Break out locating tab (1) on inside of guide sleeve (2).

Installation: Replace guide sleeve.

3

Unscrew left and right screws (3)

*000589011000

4

Remove neck rest

5

Remove neck rest guide (4)

Take care not to damage backrest cover. Replace any faulty neck rest
guides (4).

Press in snap-in lug (5) from front.

Dismantling takes place in 2 stages.

6

Remove backrest shell (6)

Swing backrest shell (6) out at top and take off.

Installation: Mount backrest shell (6) on top first, then snap in to place by pushing it down lightly.

7.1

Unclip clamps on backrest shell's storage compartment

Applies only when backrest shell (6) is renewed.

7.2

Take storage compartment out of backrest shell (6)

Applies only when backrest shell (6) is renewed.

8

Install in the reverse order

Removing and installing front seat backrest shell

Torx bit set

000 589 01 10 00

Referenced documents