P88.80-2179-04
Shown on left side of vehicle
1 Longitudinal member paneling
2 Door sill molding
P88.80-2180-09
Shown on left side of vehicle
1 Longitudinal member paneling
3 Expansion clip
4 Fender liner
8 Clip
9 Expansion clip
10 Rear fender interior trim
5 Expansion clip
6 Clip
7 Clip
| Remove/install | ||
1 | Turn clips (arrows) 90° at bottom of longitudinal member panel (1) and remove clips (arrows A) | Remove damaged clips (arrows A). | |
2 | Pull longitudinal member panel (1) out of underfloor paneling at bottom | | |
3 | Remove expansion clip (3) from fender liner rear section (4) on front axle | ||
4 | Loosen rear fender liner section (4) in area of longitudinal member panel (1) | ||
5 | Remove expansion clips (5, 9) from rear fender inner trim (10) | ||
6 | Open driver door or passenger door | ||
7 | Unclip door sill (2) from longitudinal member panel (1) and remove | Observe clips on door sill (2) on A-pillar Replace damaged clip. | |
| |||
8 | Loosen clip (8) on rear fender (arrows B) | Replace damaged clips (8). | |
| |||
9 | Loosen clips (7) on longitudinal member (arrows C) | Replace damaged clips (7). | |
| |||
10 | Loosen clips (6) from inside on fender (arrows D) | Press fender liner section (4) to side. Replace damaged clips (6). | |
| |||
11 | Remove longitudinal member paneling (1) | ||
12 | Install in the reverse order |
Long wedge
115 589 03 59 00