ar8850p5000qa

Remove/install trunk lid

Type ar · topic 88.50 · version 0200 · 2006-06-22

Applies to: MODEL 209.4

Where it sits

Function group 3 Body › 88 Detachable body components, exterior flaps › 88.50 Trunk lid — Series 209 (models 4**)

EinPAS 35 Body/frame/detachable parts › 35.36 Hood/flap/cover › 35.36.33 Liftgate/trunk lid — Series 209 (models 4**)

AR88.50-P-5000QA

Remove/install trunk lid

9.6.06

MODEL 209.4

Remove/install trunk lid

P88.50-2454-09

1 Hinge

3, 4 Bolts

2 Trunk lid

Modification notes

11.5.06

"Disconnect/connect ground line on battery" removed

 	Remove/install
 Danger!	Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Open trunk lid
2	Remove paneling from trunk lid		AR68.30-P-8150Q
3	Disconnect electric wiring harness, expose up to cable passage and remove
4	Detach gas pressure strut on one side
5	Mark installation position of both hinges (1) on trunk lid (2)
6	Loosen bolts (3) on both sides		*BA88.50-P-1009-01A
7	Unscrew bolts (4) on both sides		*BA88.50-P-1009-01A
8	Remove trunk lid (2) from both hinges (1) upward.	 Remove trunk lid (2) with aid of helper and lay down on suitable subbase
9	Install in the reverse order
10	Adjust trunk lid		AR88.50-P-5200QA

 Trunk lid

Number	Designation		Model 209


BA88.50-P-1009-01A	Bolt, hinge bracket to trunk lid	Nm	8 (2)

Referenced documents

ar6830p8150q Remove/install trunk lid paneling
ar8850p5200qa Adjust trunk lid
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.